SoakEase is a product-selective absorbent sock inside a stainless steel canister. It is used as a passive collection system for free phase product such as jet fuel, gasoline or diesel fuel from 1.25 in (3.17cm) and larger recovery wells, monitoring wells and recovery trenches.
1 in. absorbs 0.18 quart (0.17 L) of product per sockSoakEase is 36 in (0.9 m) long and is available in three sizes to accommodate specific site
2 in. absorbs 1 quart (0.95 L) of product per sock
4 in. absorbs 3 quarts (2.8 L) of product per sock
The SoakEase can be used as a bailer for periodic product removal or as a dedicated system for a more continuous method of recovery. Prior to dedicating the SoakEase, it is recommended that excess free product be removed by bailing with the SoakEase.
To use SoakEase as a bailer, an absorbent sock is placed in the stainless steel canister, a cord is attached to the support loop and then lowered through the product layer. The full length of the sock should come into contact with the product for greater recovery. Immediately the SoakEase™ will begin absorbing product at a rate of approximately 0.1 gallon (0.38 L) per second, depending on the product viscosity. After some time, the SoakEase should be raised from the well, the sock removed from the canister and disposed of in accordance with regulations.
To use the SoakEase as a dedicated system, it is necessary to determine the amount of product present using an oil/water interface indicator as well as the water table fluctuation. When these have been determined, the SoakEase may be installed to accommodate level changes of up to 36 in (0.9 m).
|Manufacturer||Durham Geo Slope Indicators|